脚本是我自己写的啊。下面这是Jlink提供的模板函数，也就是往相应的寄存器里写东西罢了。
/*********************************************************************
*
* JLink setup file - Generated by J-Flash ARM V2.16b
*
* Syntax:
* SetJTAGSpeed(x); // Sets the JTAG speed, x = speed in kHz (0 = Auto)
* Delay(x); // Waits a given time, x = delay in milliseconds
* DisableMMU(); // Disables the MMU
* Go(); // Starts the ARM core
* Halt(); // Halts the ARM core
* Reset(x); // Resets the target, x = delay in milliseconds
* ResetBP0(x); // Resets the target using breakpoint at address 0
* ResetADI(x); // Resets the target using ADI software reset
* Read8(Addr); // Reads a 8/16/32 bit value,
* Read16(Addr); // Addr = address to read (as hex value)
* Read32(Addr);
* Verify8(Addr, Data); // Verifies a 8/16/32 bit value,
* Verify16(Addr, Data); // Addr = address to verify (as hex value)
* Verify32(Addr, Data); // Data = data to verify (as hex value)
* Write8(Addr, Data); // Writes a 8/16/32 bit value,
* Write16(Addr, Data); // Addr = address to write (as hex value)
* Write32(Addr, Data); // Data = data to write (as hex value)
* WriteVerify8(Addr, Data); // Writes and verifies a 8/16/32 bit value,
* WriteVerify16(Addr, Data); // Addr = address to write (as hex value)
* WriteVerify32(Addr, Data); // Data = data to write (as hex value)
* WriteRegister(Reg, Data); // Writes a register
* WriteJTAG_IR(Cmd); // Writes the JTAG instruction register
* WriteJTAG_DR(nBits, Data); // Writes the JTAG data register
*
**********************************************************************
*/
嵌入式系统